Lightsaber hilt I designed based off a few of my favorite characters (Vader, Luke, Obi-Wan, Kanan) lightsaber is capable of fitting a 1" diameter PC blade as shown in the photos. the bottom half is hollow allowing one to place electronics or lights or just a counter balance. The hilt walls are fairly thick with proper finishing (light coat of resin) could be fensing capable. I painted mine and it looks great as a prop or wall ornament. The hilt feels perfect in my hand and is comfortable to hold ajnd swing around, I made one for my young nephew and now he uses to play and whatnot, holds up nicely. The screw holes are robust and fits I believe #4-5 screw top blade will fit similar or the standard screws used in manufactured light saber designs to hold blades. This item prints very cleanly with very little supports (only on the very bottom of the bottom section of hilt and the top half needs some on bottom and a tree support to the box area. all other parts are made with about 45deg angle for ease of printing. Model shown is using organic supports at .15mm layer height, PLA.