Commander Display Deck Box 3D print model

This 2 part box holds 100+ dragon sleeved magic cards, with the commander in a clear protector sleeve forming the front wall of the box. The protector sleeve and the registration marks will prevent the box from opening unexpectedly, if the box is difficult to open, squeeze the sides together with fingertips directly under the registration marks on the back. Avoid bending the protective sleeve while removing the lid. Try a few times without cards inside to get a feel for it.

Due to the variability in protector sleeve widths (+/- 2mm!), a little over half will fit, with the remainder being too large. The design is intended to prioritize compact storage of several boxes side by side, and adding the needed few millimeters would add up quickly. Six of these boxes will fit in an ammobox (use ribbons to lift boxes), and some shoeboxes hold 2 layers of 8.

PRINTING INSTRUCTIONS: Ensure that the bottom layer is solid. Print with 2 walls, zero infill. PLA works well, PETG can be annoyingly stringy, but feel free to deal with that as you pelase. For best results, ensure combing and avoid crossing perimeters are both OFF. If you notice that internal perimeter is not generating properly, try setting your extrusion width to 0.39mm. If you are slicing with Arachne this should not be an issue. Should cost about about a dollar per print.

I spent a very long time on the design, ensuring that this print would be durable, quick, and with as few issues as possible, while still printing quickly and with low material use. I really appreciate your patronage if you choose to buy this design. I have spent over 18 hours just testing and tuning the design.

Feel free to tip me on paypal.me/melonbrain