Gray Visitor from Zeta Reticuli 3D print model

In the year 2047, long after Earth had abandoned hope of contact, a lone craft descended without warning into the Great Basin. From it emerged a silent envoy—tall, emaciated, and featureless, save for its massive dark eyes. The being was not hostile but observed, measured, and waited. Humanity would come to know him as “the Watcher from Zeta Reticuli,” a representative of the ancient Gray Collective.

This printable figurine depicts a classic Gray alien archetype, standing upright with elongated limbs, three-fingered hands, thin humanoid form, and the iconic oversized head and black almond-shaped eyes. The model is ideal for collectors, sci-fi RPG encounters, extraterrestrial dioramas, and as a decorative piece for UFO enthusiasts.

Designed with clean anatomical lines and neutral posture, the model is optimized for both monochrome and full-color presentation. This alien is part of the Tidewalkers faction in the Legends of Aevaris universe—mystical explorers and dimensional navigators who emerged from deep oceanic starscapes.“Though his vessel rides the solar tide, his mind echoes through the Nexus.”

Please note that the model is primarily designed for textured versions (OBJ + MTL in ZIP archive), allowing for a rich and visually detailed result when used with color-supported 3D printing or digital rendering. The non-textured version (STL, 3MF) may lack some surface details visible in the textured formats.

Technical Features and Printing Recommendations:

Recommended Printing Technology: SLA, DLP or FDM with fine nozzle

Supports Required: Yes, especially under arms and head curvature

Recommended Print Size: 100–150 mm height for tabletop, 200+ mm for display piece

Recommended Material: Resin for fine detail, PLA for affordability

Minimum Print Time: ~3 hours at 120 mm height

Estimated Material Use: ~25–40g depending on scale and support density

Scaling Note: This model is designed in millimeters (mm). If it appears too small when imported into your slicer, ensure your software is set to mm units. If needed, scale the model up 100x if the slicer defaults to meters instead.