A statue of ondine to refresh and bring a serene atmosphere.

It is designed to work with an indoor submersible fountain pump.

No support is required.

The legs (piece 3) are connected to the chest with the low pad (piece 4) and the chest is connected to the head with the upper right and left pads (pieces 5 and 6).

Depending on the result you want to achieve, you can put the bowl on your hands ( piece 7).

Everything is placed on the tank on the support provided for this purpose (part 8) the passage for the wire is at the back.

The submersible pump ( 36 x 36 x 30 mm) is connected to the statue with a small pipe (diameter 12 mm outside) so that it is under water.

the whole measures 32 cm in total height.

more 3d model https://www.cgtrader.com/fabricejeanpier

3D PRINTING SETTINGSExtruder: 200°C and bed: 55°C

Layer height: 0.2 mm

Vertical hulls, perimeter: 3

Horizontal hulls, solid roof: 3 and below: 3

Filling density: 50%.

Speed perimeter: 30 mm / s

no brackets