F-11 Blaster - 3D Print Ready 3D print model
This F-11 blaster has been modelled in a very high resolution and is suitable for print and casting, and like all our other models - to you prop makers out there, we wish you the best. Cast away!
501's approved? No and we won't. Often they are actually wrong! nothing worse than following their guides only for people to point out mistakes you DIDN'T want to make but had to because it was " 501 spec" you were following.
Next time you have a 501st member tell you your suit isn't good enough, ask them the last time they did some charity work instead of taking selfies of themselves.
The poly count was so high, many bothans died in the attempt to get you these plans. It has been optimized and as you can see from the photos test printed.
It has been cut and plated (as we always do for you) and is a relatively simple print in 10 parts and has been scaled accurately.
*A big thanks to J.Redding for the test print and photo.
**Uncut blaster is available on request after purchase.