Automatic wire sticking laser cutting and receiving line 3D model

The applicable products of this equipment are: industrial wire, FPC, FFX flexible cable, 0.3-1MM wire diameter, various products glued laser cutting, etc. This equipment is mainly a copper wire cutting and processing equipment mainly used for cutting and pasting of copper wire FPC flexible cable. The main highlight of the equipment is the feeding rack part of the wire material and the complicated pasting structure. The rack can load dozens of coils of wire at a time. The main functions of the equipment are: 1. Wire feeding and feeding, 2. Wire ultrasonic cleaning, 3. Wire body sticking tape mechanism, 4. Soft cable laser cutting and peeling, 5. Cable cable Cutting, 6. Flexible wire automatic rewinding manipulator, 7. Automatic feeding tray circulating conveyor belt, equipment bus is integrated and fully automatic operation, manual loading and unloading, loading rack structure The loading rack can be applied to various sizes The wire copper wire FPC flexible cable with the specifications of the reel is simple, and the loading and unloading operation is simple. Only the wire is inserted into the rotating shaft of the feeding rack. The copper wire in the material rack is ultrasonically cleaned after passing through the drum and the wiring harness arrangement structure. The cleaned wires enter the glue applicator, the incoming material of the wire body can be arranged with more than 30 wires, the number of wires can be automatically selected and arranged, the size of the glue tape can also be selected, and the wires enter the glue station At the time, the adhesive tape is pulled out and cut by the adhesive pulling mechanism and then attached to the wire. The upper and lower sides are attached together to bind the wires together. The adhesive pulling structure of the electric core is a stepping motor. The moving structure is complicated. The switchboard uses 2 servos. The motor is composed of a stepping motor and more than ten cylinders. This is a complex structure for sticking paper. The labeling head and suction label are vacuum suction type. The length of the sticking position can be adjusted according to the requirements. The adjustable range is compared. The large wire feeding structure is also ingeniously designed. The glue position of the cable is segmented, and the laser cutting of the surface is also cut at the back end of the glue. After the laser cutting, the line body is cut by the cutting machine, and the length of the cut is It is manually set, and the cutting is completed. The reclaiming manipulator directly grabs it into the receiving box. The receiving box is recycled and transported by the discharge conveyor belt. The conveyor belt has a total of 6 small motors, each of which is a section. There are 2 conveyor belts, 2 second-stage conveyor belts and 2 jacking transfer machines each. The conveyor belt is divided into one in and one out. The feeding conveyor is on the left and the discharge conveyor is on the right, and the left is in the feeding conveyor belt. The carrier is in the state of the product. When the product is used up, the empty carrier tray or blister tray will be lifted by the lifting transfer conveyor to the empty conveyor belt on the right, and then the empty tray will be recycled , The motor power of this conveyor belt is relatively small, and the products conveyed are relatively light, so the round belt design is used, which is very convenient in installation and debugging, and the round belt is relatively wear-resistant, and it is very convenient to replace it. There are more complicated movements in the equipment and there are many cylinder structures. Most of the structures can be seen from the pictures. Those in need and interested can download the learning drawings. The content is very good. After downloading, you can analyze and study in detail. , You can learn a lot of things, I won’t give more detailed introduction here, the above is the whole structure and working principle of this equipment.