MiG-29SMT Cockpit Low-poly 3D model

I recently purchased this and have tried to print it three times with no success. When I purchased this I had thought it would print in several sections/sides and then be assembled when done. It prints as one complete unit. Its one file. I tried with out support and that failed about 1 hour in. I then tried with supports from the build surface all around, and it failed about 5-6 hours in. Any insight as to how to set this up in CURA would be helpful.

I am quite busy at the moment, but I will try to help you set it up as soon as I can. Just send me the printer model you have, so that I can cut the model up into smaller pieces and set the model up in CURA. I will also need the scale you would like the model to have in real life. For further support, please refer to me in the CGTrader conversation section (messages), not in the comments.

Will do and thank you very much, I appreciate it! Just sent a message.

A model of the MiG-17 cockpit would be useful!!